1/2 (Dia.) Bearing Flush Trim Bit, Freud flush router bit in my opinion

A yesterday. I search for information on the 1/2" (Dia.) Bearing Flush Trim Bit, so i would like to describe here.

I purchased this bit for use in my Bosch router mounted on a table. I used my old bits a lot and was cheaper quality. the bearing has stopped once and so I decided not to skimp on replacing. I didn't expect much from this bit because I use lame Freud in all my saws. did not disappoint. Super strong and cut fast and smooth, even when doing model cuts with 3/4 solid Ash. If you need multi wire very highly.

1/2" (Dia.) Bearing Flush Trim Bit with 1/2" Shank From the Manufacturer Bottom bearing flush trim bit for trimming laminate counter tops and doing pattern work. These are the bits to rely on for a smooth, burn-free cut. Two flutes provide faster cutting and a superior finish. Features Freud's TicoHi-Density Carbide, Perma- Shield Coating, and Tri-metal brazing. I/2" diameter, .... Read more or Check Price